Select Page

When drywalling there are tools that are necessary for you to get the job done right. If drywall is installed incorrectly it is not only an eyesore but can also pull away from the wall and warp. There are a lot of tools that are needed when drywalling, but each will make the process smoother and give you a finished product that you’ll be proud of.

Here are the 14 tools that you need to drywall:

  1. Dust Mask

It may seem obvious, but a dust mask is crucial when you go to drywall. It will protect you from breathing in plaster dust which can be kicked up while drywalling. This tool is incredibly inexpensive and can end up saving your lungs.

  1. Pencil

Another obvious one that just can’t be left out. You can use any old pencil, but you do need it so that you can mark lines and measurements. A contractor’s pencil is a bit more pricey than your standard HB variety, but they are made to last.

  1. Screw Driver

A simple screwdriver runs around $3-$6, but you need one that has the appropriate head – one that will match the drywall screws you have purchased. A screwdriver is used to tighten up screws as well as remove them if a hole is made in the drywall sheet.

  1. Compass

This tool is used to help make circular holes in drywall. This is especially necessary when cutting out holes for light fixtures.

  1. Drill

You can use any drill for installing drywall, as long as the correct attachments are sold with it. Drills that you can set the depth of so that you don’t break the paper you’re installing are recommended. There are many drill brands specifically made for installing drywall.

  1. Tape Measure

A tape measure is another obvious tool that you need to complete any construction job. It should be at least 12 ft long and have a wide blade.

  1. Drywall Square

The drywall square is the quintessential tool for drywalling. It is used to make straight cuts but can also be used for measuring drywall as well. It is more expensive than your standard measuring device but there is no other option when drywalling.

  1. Box Knife

A box knife is a tool that you use to cut drywall. Investing in a good one with interchangeable razor blades is your best bet.

  1. Inside Corner Knife

The inside corner knife does exactly what it sounds like it does. It is used to put drywall mud on the inside of corners.

  1. Drywall Mud Pan

The drywall mud pan is simply the receptacle that you use to store drywall mud. It is small so you can remain mobile while applying drywall mud.

  1. Drywall Knives

Drywall knives are the tools used for spreading mud across drywall seams. They come in a variety of sizes and are good for almost all jobs, aided only by the inside corner knife.

  1. Drywall Keyhole Saw

This device is what you use to cut holes into drywall for outlets and light fixtures.

  1. Sanding Blocks

These are an absolute necessity to get your drywall smooth and perfect. Typically 150 grit sandpaper is used to finish drywall.

  1. Pole Drywall Sander

This is a modified sander for drywall. It is a sander attached to a 3-4 foot wooden pole to help a drywaller reach difficult spots and to save them from reaching too high.

 


CALL


EMAIL


MAP